Renacon Renafix 222 Tile Adhesive

  Renafix 222 Thin set tile adhesive is a multi-purpose, polymer modified thin set powder offering vast utility including applications on interior floor & wall as well as limited exterior* floor & wall installations, It is a cementetious thin set powder to be mixed only with water to install various types of tiles & stone on variety of substrates using thin set method of installation.

ADVANTAGES:

• Single component, just add water
• High strength, polymer modified
• Economical & Easy to use
• Bonds to various substrates
• Exceeds EN12004 / ISO13007 for C2TES1 and exceeds ANSI 118.4
• Classification
• Suited for demanding external application

SUITABLE SUBTRATES:

• ·  Concrete
• Concrete Masonry Cement Mortar Beds
• Cementetious  Plaster and render
• Tile and Stone
• Brick Masonry
• Cement Terrazzo

WORKING PROPERTIES:

• ·  Single Component
• Extended Open Time up to 30 minutes at 27 deg C
• Good Pot Life up to 2 hr 30 minutes at 27 deg C
• Excellent adhesion
• High bond strength
• Flexible
• Ready to use

INSTALLATION:

• ·  Surface Preparation –Surfaces should be structurally sound, clean and free of all dirt, oil, grease, loose peeling paint, laitance, concrete sealers or curing compounds. Dry, dusty concrete slabs or masonry should be dampened and excess water swept off.
• Mixing –Place clean, potable water into a clean pail. Add thin set powder into the pail. Use approximately 5 – 6L of water for 20 kg of powder. Mix by hand or with a slow speed mixer to a smooth, trowel able consistency. Allow adhesive to slake for 5-10 minutes. Adjust consistency if necessary. Remix and apply with the proper sized notched trowel.
• Application –Apply adhesive to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to ensure full bedding of the tile. Spread as much adhesive as can be covered with tile in 10 minutes. Back butter large tiles (> 12”x12”) to provide full bedding and firm support. Place tiles into the wet, sticky adhesive and beat in using a beating block and rubber mallet to embed tile and adjust the level. Check adhesive for complete coverage by periodically removing a tile and inspecting bedding adhesive transfer onto back of the tile. If adhesive is skinned over (not sticky), remove and replace with fresh adhesive. It is recommended to use spacers to create joints between tiles and subsequently fill the joints with Renafix tile grout.
• Cleaning –Clean all tools and application equipment with water immediately after use. Hardened/cured material can only be removed mechanically.

CAUTIONS:

       ·  Health & Safety Information

• During cold weather, protect finished work from traffic until fully cured.
• Contains Portland cement and silica sand. May irritate eyes and skin. Avoid contact with eyes or prolonged contact with skin. In case of contact, flush thoroughly with water.
• Do not take internally. Silica sand may cause cancer or serious lung problems. Avoid breathing dust. Wear a respirator in dusty areas.
• Keep out of reach of children.